Bobcat Company 442 — Assembly

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-141 Assembly (Cont'd) Figure 20-52-139 3 2 1 3 N-15291 2 1 Apply clean grease to the three pins (Item 1) [Figure 20- 52-141] and install them in the appropriate groove. N-15283 Install the washer (Item 2) and the spring (Item 3) [Figure 20-52-141] . Apply Loctite™ 241 and install the torque limiter plate (Item 1) and bolt (Item 2) on the swash plate (Item 3) [Figure 20-52-139] . NOTE: If the rotating group is damaged, the parts can not be ordered separately and must be order as an assembly.

Figure 20-52-140 Figure 20-52-142 1 2 3 2 1 2 3 N-23393 N-15299 Install the cradle (Item 1) on the shaft (Item 2) [Figure 20-52-140] . To compress the spring inside the cylinder block, use a threaded rod (or bolt) (Item 1), 2 trimmed washers (Item 2) and 2 nuts (Item 3) [Figure 20-52-142] . 442 Excavator 20-52-49 Service Manual