HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-145 Assembly (Cont'd) Figure 20-52-143 2 1 4 4 2 1 N-15290 4 3 NOTE: The modified washer (Item 1) [Figure 20-52- 144] must fit over the spring, but must also fit inside the snap ring (Item 2) [Figure 20-52- 145]. N-15289 Install the threaded rod and nut (Item 1) through the modified washer (Item 2) and the block assembly (Item 3) [Figure 20-52-143] . Tighten the nut (Item 1) until the spring is compressed enough to install the snap ring (Item 2) [Figure 20-52- 145] . NOTE: The modified washer (Item 2) must fit between the three pins (Item 4) [Figure 20-52-143].
Remove the threaded rod/washer assembly. Figure 20-52-144 Figure 20-52-146 1 2 1 3 N-15288 P-58616 Install the retainer (Item 1) [Figure 20-52-146] . Install the second modified washer (Item 1) over the threaded rod (Item 2) [Figure 20-52-144] . Install the nut (Item 3) [Figure 20-52-144] on the threaded rod. 442 Excavator 20-52-50 Service Manual