Bobcat Company 442 — Assembly

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-149 Assembly (Cont'd) Figure 20-52-147 1 2 N-15276 Lay the pump housing on its side and install the rotary group assembly, swash plate, and shaft in the housing [Figure 20-52-149] . P-58615 Figure 20-52-150 Install the piston assembly (Item 1) in the cylinder block (Item 2) [Figure 20-52-147] . NOTE: It is NOT important that the pistons are installed in their original positions. Figure 20-52-148 1 1 2 N-23390 Set the pump housing in the up-right position [Figure 20- 52-150] . Install the shim washer (Item 1) [Figure 20-52-150] .

For procedure to determine shim washer thickness see [Figure 20-52-137 on Page 48] . N-15281 Slide the rotary group assembly (Item 1) on the shaft (Item 2) [Figure 20-52-148] . 442 Excavator 20-52-51 Service Manual