HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-153 Assembly (Cont'd) 1 Figure 20-52-151 1 1 1 2 1 N-23397 Install the 4 O-rings (Item 1) [Figure 20-52-153] on the back port assembly. P-58617 Figure 20-52-154 Install the bearing (Item 1) [Figure 20-52-151] on the shaft. 1 Install the O-ring (Item 2) [Figure 20-52-151] . 2 Figure 20-52-152 2 N-23431 Grease the inside of the control piston (Item 1) [Figure 20-52-154] . 1 Slide it over the control piston shaft (Item 2) [Figure 20- 52-154] . 3 N-23399 Install the valve plate (Item 1) on the back port assembly.
The valve plate can only be installed one way by aligning the groove (Item 2) with the pin (Item 3) [Figure 20-52- 152] . 442 Excavator 20-52-52 Service Manual