Bobcat Company 442 — Assembly

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-157 Assembly (Cont'd) Figure 20-52-155 1 1 2 P-58611 Apply Loctite™ 241 on the bolt (Item 1) and install the load sensing assembly (Item 2) [Figure 20-52-157] . Tighten to 10 ft.-lbs. (13 Nm) torque. P-58618 Install the torque limiter valve. (See Torque Limiter Valve Removal and Installation on Page 20-52-17.) Install the stroking piston and spring (Item 1) [Figure 20- 52-155] . Install the pump control assembly. (See Pump Control Removal And Installation on Page 20-52-29.) Figure 20-52-156 Place the hydraulic piston pump on its side and fill approximately half full.

1 Install a new O-ring on the plug. Figure 20-52-158 2 2 P-58614 1 Align the marks and install the back port assembly (Item 1) [Figure 20-52-156] on the pump housing. Install the 4 bolts (Item 2) [Figure 20-52-156] . Tighten the bolts to 88 ft.-lb. (119 N•m) torque. P-58613 Install the plug (Item 1) [Figure 20-52-158] in the pump and tighten. 442 Excavator 20-52-53 Service Manual