TRAVEL MOTOR (CONT’D) Figure 20-70-125 Assembly (Cont’d) 1 Figure 20-70-123 2 1 P-61810 Install the bearing (Item 1) [Figure 20-70-125] . P-61604 Figure 20-70-126 Install the spacer (Item 1) and snap ring (Item 2) [Figure 20-70-123] . 1 Figure 20-70-124 2 2 1 P-46426 Install the O-ring (Item 1) on both seal rings (Item 2) [Figure 20-70-126] . P-61787 NOTE: Inspect the seal ring for burrs before installing the O-ring. Install the O-ring making sure it is not twisted. To remove any twists, gently pull a section of the O-ring and let it snap back. Install the spacer (Item 1) and bearing race (Item 2) [Figure 20-70-124] .
The O-ring, seal ring, hub assembly, and bearing carrier must be clean and free of any dust, oil film, or foreign matter. The O-ring and seal ring assembly has to be lubricated with rubbing alcohol, so the O-ring will slip past the housing retaining ring and seal uniformly in the housing radius. Dip the O-ring and seal ring assembly in a pan of alcohol. 442 Excavator 20-70-33 Service Manual