SWING MOTOR DRIVE CARRIER (CONT’D) Removal And Installation (Cont’d) Figure 20-91-5 1 1 P-38650 Install two mount bolts (Item 1) [Figure 20-91-5] in the threaded holes of the carrier. Tighten the bolts evenly to push the carrier off of the upper structure. Figure 20-91-6 1 2 3 P-38651 Remove the tee (Item 1) and hose (Item 2) [Figure 20- 91-6] from the hydraulic reservoir. Remove the wire harness (Item 3) [Figure 20-91-6] from the hydraulic reservoir. Remove the carrier. 442 Excavator 20-91-2 Service Manual