SWING MOTOR DRIVE CARRIER (CONT’D) Figure 20-91-51 Assembly (Cont’d) Figure 20-91-49 1 P-40017 Press the top bearing on the shaft [Figure 20-91-51] . P-40016 Figure 20-91-52 Install the shaft (Item 1) [Figure 20-91-49] in the carrier. Figure 20-91-50 1 P-40000 1 Install the inner nut (Item 1) [Figure 20-91-52] . Tighten the nut to 147-221 ft.-lb. (200-300 N•m) torque to seat the bearings. P-40014 Apply clean hydraulic fluid or assembly lube to the top bearing (Item 1) [Figure 20-91-50] . Loosen the nut 15 to 30 degrees after the inner nut has been installed. The shaft should turn when 1.5-3.7 ft.-lb. (2-5 N•m) of force is applied to the shaft. 442 Excavator 20-91-15 Service Manual