SWING MOTOR DRIVE CARRIER (CONT’D) Figure 20-91-83 Assembly (Cont’d) Figure 20-91-81 1 1 2 2 P-38906 Install the brake housing (Item 1) [Figure 20-91-83] on the carrier. P-38910 Install the snap ring (Item 1) [Figure 20-91-81] . Install the four bolts (Item 2) [Figure 20-91-83] . Tighten the bolts to 63 ft.-lb. (86 N•m) torque. Figure 20-91-82 Figure 20-91-84 1 1 P-38909 P-40038 Install the O-ring (Item 1) [Figure 20-91-82] . Install the driveshaft (Item 1) [Figure 20-91-84] . 442 Excavator 20-91-23 Service Manual