Bobcat Company 442 — Handle Removal And Installation

RIGHT CONTROL LEVER (JOYSTICK) (CONT’D) Figure 20-110-5 Handle Removal And Installation Figure 20-110-3 1 1 1 P-35945 Disconnect the wire harness (Item 1) [Figure 20-110-5] . P-33029 Figure 20-110-6 Remove the 2 bolts (Item 1) [Figure 20-110-3] and washers. Remove the right arm rest. Figure 20-110-4 1 1 1 P-35946 1 Mark the wires to the connector bodies (Item 1) [Figure 20-110-6] . 2 P-35944 Use a small flat blade screwdriver to depress the wire terminal tabs, and remove the individual wires from the connector body. Remove the 4 bolts (Item 1) [Figure 20-110-4] and washers. Installation:

Use a small flat blade screwdriver to rebend the wire terminal tabs on each wire before installing the individual wires in the connector bodies. Remove the cover (Item 2) [Figure 20-110-4] . 442 Excavator 20-110-2 Service Manual