Bobcat Company 442 — Disassembly And Assembly

BOOM OFFSET VALVE (CONT’D) Figure 20-190-33 Disassembly And Assembly (Cont’d) Figure 20-190-31 5 4 1 2 3 2 1 P-35994 Remove the bolt (Item 1) and seal carrier (Item 2) [Figure 20-190-32] from the fittings. P-36231 Remove the retainer (Item 1), piston (Item 2) spring (Item 3) and shims (Item 4) from the spool (Item 5) [Figure 20- 190-31] . Figure 20-190-34 Figure 20-190-32 2 2 1 P-35998 1 Installation: The lip (Item 1) on the seal carrier must fit in the groove (Item 2) [Figure 20-190-34] in the housing. P-36278 Remove the two fittings (Item 1) [Figure 20-190-32] from the end of the valve body. NOTE: Do not remove the 2 fittings (Item 2) [Figure 20-190-32].

The fittings are welded to the valve block. Removing the fittings will damage the block and fittings. 442 Excavator 20-190-6 Service Manual