BOOM OFFSET VALVE (CONT’D) Figure 20-190-37 Disassembly And Assembly (Cont’d) 1 Figure 20-190-35 1 P-35996 Remove the O-ring (Item 1) [Figure 20-190-37] from the bolt. P-35995 Remove the seal (Item 1) [Figure 20-190-35] from the seal carrier. Installation: Clean all components with solvent and dry with compressed air. Figure 20-190-36 Inspect all parts and replace any that are damaged. 2 Use new O-rings and back-up rings. Apply clean hydraulic oil to the O-rings and back-up rings during assembly. 1 2 P-35997 Installation: Make sure the lips (Item 1) on the seal fit into the grooves (Item 2) [Figure 20-190-36] on the seal carrier. 442 Excavator 20-190-7 Service Manual