HYDRAULIC PISTON PUMP DRIVE COUPLER Figure 20-230-6 Removal And Installation Drain the hydraulic reservoir. (See Replacing The Hydraulic Oil on Page 10-100-2.) Remove the muffler. (See MUFFLER (S/N 522311001 & ABOVE) on Page 60-20-1 or See MUFFLER (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) on Page 60-21-1.) 1 Figure 20-230-4 P-38128 Figure 20-230-7 1 P-35231 Loosen the clamp (Item 1) [Figure 20-230-4] . Rotate the clamp to provide clearance to the suction fitting bolts. 1 Figure 20-230-5 P-38129 Remove the 2 pump mount bolts (Item 1) [Figure 20- 230-6] & [Figure 20-230-7] and washers. Installation: Tighten the bolts to 125-140 ft.-lb. (170-190 N•m) torque.
1 Slide the pump away from the engine. 1 P-35232 Remove the 4 bolts (Item 1) [Figure 20-230-5] . 442 Excavator 20-230-1 Service Manual