Bobcat Company 442 — Checking And Adding Hydraulic Oil

HYDRAULIC SYSTEM Figure 10-100-2 Checking And Adding Hydraulic Oil Put the machine on a flat level surface. Retract the arm and bucket cylinders, put the bucket on the ground and raise the blade. Stop the engine. Open the rear cover. Figure 10-100-1 1 P-32851 Clean the surface around the reservoir (breather) cap and remove the cap from the reservoir (Item 1) [Figure 10-100-2] 1 Add the correct oil to the reservoir until it is visible in the sight gauge. (See FUEL, COOLANT AND LUBRICANTS on Page SPEC-70-1.) P-32695 Check the breather cap and clean as necessary. Replace the cap if damaged. Check the hydraulic oil level, it must be visible in the sight gauge (Item 1) [Figure 10-100-1] .

Install the reservoir cap. Close the rear cover. 442 Excavator 10-100-1 Service Manual