HYDRAULIC SYSTEM (CONT’D) Remove the drain hose and install the cap on the hydraulic reservoir. Replacing The Hydraulic Oil Add fluid to the reservoir. (See FUEL, COOLANT AND LUBRICANTS on Page SPEC-70-1). See the Service Schedule for the correct service interval. (See SERVICE SCHEDULE on Page 10-50-1). Retract the arm and bucket cylinders, lower the bucket to the ground. Stop the engine. Run the machine through the hydraulic functions. Stop the engine. Check the fluid level and add as needed. Open the rear cover. Figure 10-100-3 WARNING Always clean up spilled fuel or oil. Keep heat, flames, sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause explosion or fire which can result in injury or death. 1 W-2103-1285 WARNING Diesel fuel or hydraulic fluid under pressure can penetrate skin or eyes, causing serious injury or death. Fluid leaks under pressure may not be visible. Use a piece of cardboard or wood to find leaks. Do not use your bare hand. Wear safety goggles. If fluid enters skin or eyes, get immediate medical attention from a physician familiar with this injury. P-32899 Remove the cap (Item 1) [Figure 10-100-3] from the hydraulic reservoir drain. W-2072-0496 Figure 10-100-4 1 P-32900 Install the drain hose (Item 1) [Figure 10-100-4] on the hydraulic reservoir.
Tighten the hose until oil starts to drain from the reservoir. Drain the fluid into a container. Recycle or dispose of the fluid in an environmentally safe manner. 442 Excavator 10-100-2 Service Manual