TRACKS (CONT’D) Rubber Track Removal And Installation WARNING Fully raise the blade. Put jack stands under the blade and rear corners of the undercarriage before working under the machine. Failure to block up the machine may allow it to move or fall and result in injury or death. Figure 30-20-14 W-2218-1195 Stop the engine and exit the excavator. Figure 30-20-16 1 1 1 2 P-40663 Use the boom and arm to lift the blade end of the machine and install jack stands (Item 1) [Figure 30-20- 14] under the blade. Figure 30-20-15 P-32891 Loosen the top bolt (Item 1) [Figure 30-20-16] . Remove the bottom bolt and washer (Item 2) [Figure 30- 20-16] . Pivot the cover out of the way.
1 P-40662 Swing the upperstructure 180 Ч and use the boom and arm to lift the opposite end of the track frame and install jack stands (Item 1) [Figure 30-20-15] under the frame. 442 Excavator 30-20-6 Service Manual