TRACKS (CONT’D) Figure 30-20-19 Rubber Track Removal And Installation (Cont’d) Figure 30-20-17 1 1 P-40670 Insert a second steel rod or pipe (Item 1) [Figure 30-20- 19] , at a distance of two lugs, between the track and the idler wheel. Continue to turn the track until the first pipe contacts the track frame. P-32974 To release track tension, loosen the tensioner (Item 1) [Figure 30-20-17] . Do not remove the tensioner. Stop the engine. After track tension has been released, remove all grease from the tensioner area. Figure 30-20-20 Start the engine. Slowly turn the track in the forward direction.
Figure 30-20-18 1 P-40671 1 Insert a pry bar (Item 1) [Figure 30-20-20] between the track and the idler wheel and pry out on the track until the track slides off the idler wheel. P-40669 Remove both steel rods. Insert a steel rod or pipe (Item 1) [Figure 30-20-18] (approximately 1.750 inch [44.5 mm] diameter) between the track and track frame. 442 Excavator 30-20-7 Service Manual