TRACK FRAME (CONT’D) Figure 30-30-6 Disassembly And Assembly (Cont’d) Figure 30-30-4 1 1 2 1 P-40708 Use wood blocks (Item 1) [Figure 30-30-6] to support the track. P-40858 Remove the track tension fitting (Item 1) [Figure 30-30- 4] . Figure 30-30-7 Remove the two bolts (Item 2) [Figure 30-30-4] . Installation: Tighten the bolts to 48-55 ft.-lb. (65-75 N•m) torque. 2 Figure 30-30-5 1 1 P-40709 Remove the nut (Item 1) [Figure 30-30-7] and washer from both sides of the roller. Installation: Tighten the nut to 125-140 ft.-lb. (170-190 N•m) torque. 2 P-40859 Remove the roller (Item 2) [Figure 30-30-7] . Remove the grease cylinder (Item 1) and plate (Item 2) [Figure 30-30-5] .
See Upper Roller Disassembly And Assembly. (See UPPER TRACK ROLLER on Page 30-50-1.) See Grease Cylinder Disassembly And Assembly. (See GREASE CYLINDER on Page 30-70-1) NOTE: The track does not need to be removed to remove and install the top or bottom rollers. If the track is installed, lift and block the excavator and relieve track tension. (See Track Adjustment on Page 30- 20-4.) 442 Excavator 30-30-2 Service Manual