Bobcat Company 442 — Assembly

TRACK IDLER (CONT’D) Apply a light film of oil to both metal seal rings. Assembly (Cont’d) NOTE: Do not get any oil on the rubber O-rings. Figure 30-40-19 Figure 30-40-21 1 1 P-40754 P-40875 Place the seal assembly (Item 1) [Figure 30-40-19] in the installation tool. Install the shaft/mount assembly (Item 1) [Figure 30-40- 21] in the idler. The O-ring and seal ring assembly has to be lubricated with alcohol, so the O-ring will slip past the housing retaining ring and seal uniformly in the housing radius. Figure 30-40-22 Dip the O-ring and seal ring assembly in a pan of alcohol. 1 Figure 30-40-20 1 P-40754 Place the seal assembly (Item 1) [Figure 30-40-22] in the installation tool.

P-40874 The O-ring and seal ring assembly has to be lubricated with alcohol, so the O-ring will slip past the housing retaining ring and seal uniformly in the housing radius. Shake off the excess alcohol and install the seal assembly (Item 1) [Figure 30-40-20] in the idler. Dip the O-ring and seal ring assembly in a pan of alcohol. Use firm even pressure on the installation tool to pop the O-ring into the housing. Remove the installation tool. The seal assembly stand off height must be equal and the O-ring must not be twisted. 442 Excavator 30-40-7 Service Manual