TRACK IDLER (CONT’D) Figure 30-40-25 Assembly (Cont’d) Figure 30-40-23 1 1 P-40878 Install the O-ring (Item 1) [Figure 30-40-25] on the shaft. P-40876 Apply a light film of oil to both metal seal rings. Shake off the excess alcohol and install the seal ring assembly (Item 1) [Figure 30-40-23] in the idler. NOTE: Do not get any oil on the rubber O-rings. Use firm even pressure on the installation tool to pop the O-ring into the housing. Figure 30-40-26 1 Remove the installation tool. Figure 30-40-24 P-40879 1 Install the mount (Item 1) [Figure 30-40-26] on the shaft. P-40877 The seal assembly stand off height must be equal and the O-ring (Item 1) [Figure 30-40-24] must not be twisted.
442 Excavator 30-40-8 Service Manual