Bobcat Company 442 — Cutting Of Steel Cords

TRACK DAMAGE IDENTIFICATION Causes Of The Damage: Cutting Of Steel Cords When applied to rubber tracks under the following circumstances, tension in excess of the breaking strength of the embedded steel cords causes steel cords to be cut: The following pages show photos and illustrations of track damage and the probable cause of the damage. It is intended to be used for identifying the reason for track damage and how to avoid future track damage. Figure 30-80-3 Damage: Figure 30-80-1 PI-13035 When the rubber track is detracting, the idler or sprocket rides on the projections of the embedded metal [Figure 30-80-3] .

P-3864 Figure 30-80-2 When the rubber track is detracted, projections of rubber tracks get stuck between the frame of the undercarriage. The rubber track is clogged with stones or foreign obstacles. Furthermore, when moisture invades through a cut on the lug side rubber surface, the embedded steel cords will corrode. The deterioration of the design strength may lead to the breaking off of the steel cords. Prevention: The following preventions should be taken to minimize the risk of this damage: Periodical checking on site of the recommended track tension. (See TRACKS on Page 30-20-1.) Embedded steel cords are cut off [Figure 30-80-1] & [Figure 30-80-2] .

Avoiding quick turns on bumpy and rocky fields. Replacement: Drive carefully to avoid having stones and other articles clog the rubber tracks. Replacement is required [Figure 30-80-1] & [Figure 30- 80-2] . Driving over sharp objects should be avoided. If this is impossible, do not make turns while driving over sharp objects. 442 Excavator 30-80-1 Service Manual Steel Cords PI-13034