TRACK DAMAGE IDENTIFICATION (CONT’D) Causes Of The Damage: Abrasion Of Embedded Metals When the track rollers, sprockets and idler gears roll over the embedded metals, abrasion of embedded metals is inevitable. The following cases sometimes accelerate their abrasion: Damage: Figure 30-80-4 Rubber tracks are driven with an extraordinary heavy load on them. Rubber tracks are used on sandy fields. Prevention: As long as rubber tracks are used under normal operating conditions, abnormal abrasion is unlikely to occur.
The level of abrasion should be carefully checked when the machines are used for dozing which generate a heavy load for rubber tracks, and when they are operated under a sandy field condition for a long time. P-3865 In proportion to the service time, embedded metals will gradually wear away by friction [Figure 30-80-4] . Replacement: Figure 30-80-5 Replacement is required when the width of the embedded metals (D1) becomes 67% of their original width (D) [Figure 30-80-5] . 442 Excavator 30-80-2 Service Manual Abrasion D1=0.67D D PI-13037 Abrasion D1=0.67D D PI-13037 PI-13037