TRACK DAMAGE IDENTIFICATION (CONT’D) Figure 30-80-8 Separation Of Embedded Metals Damage: Guide Figure 30-80-6 PI-13040 When a rubber track is detracted, it becomes stuck between the guide or the undercarriage frame, causing the separation of embedded metals [Figure 30-80-8] . P-4379 Figure 30-80-9 Extraordinary outer forces applied to embedded metals cause their separation from the rubber track's body [Figure 30-80-6] . Replacement: Even a partial separation of embedded metals requires replacement of the track. Abrasion Causes Of The Damage: Embedded metals are adhered between the steel cords and the rubber body.
The following cases generate external forces greater than the adhesion strength, causing separation of the embedded metals: Figure 30-80-7 PI-13041 Abnormally worn sprockets as shown will pull embedded metals out [Figure 30-80-9] . Idler Prevention: Similar to the prevention against the cutting of the steel cords: Rubber Track Recommended track tension should be periodically checked. (See TRACKS on Page 30-20-1.) Quick turns on bumpy and rocky fields should be avoided. PI-13039 If abnormal wear of sprockets is observed, they should be immediately replaced. When the idler continually rides on the projections of embedded metals, the embedded metals will eventually peel off [Figure 30-80-7] .
442 Excavator 30-80-3 Service Manual