Bobcat Company 442 — Separation Of Embedded Metals Due To Corrosion

TRACK DAMAGE IDENTIFICATION (CONT’D) Causes Of The Damage: Separation Of Embedded Metals Due To Corrosion Figure 30-80-11 Embedded Metal Damage: Figure 30-80-10 Good Separation of Bonded Rubber Cover PI-13043 Embedded metals are bonded to the rubber body. The following operating conditions cause embedded metals to corrode, causing deterioration of the bonding, and finally resulting in separation of the embedded metals from the rubber body [Figure 30-80-11] . P-4378 Due to corrosion of embedded metals, the adhesion to the rubber body deteriorates, resulting in complete separation [Figure 30-80-10] . Excessively salty fields, like the sea shore. Replacement:

Strong acidic or alkali soil conditions Even a partial separation of embedded metals requires a rubber track replacement. Compost spread grounds On tracks that are out of adjustment, the track rollers, idlers and sprockets will gradually wear the rubber surface at track roller side, causing exposure of the embedded metals. Consequently the embedded metals will corrode resulting in their separation from the rubber body. Prevention: If rubber tracks are used under such field conditions as described under (Causes of the damage), they should be washed with plenty of water. After being completely dried, they should be stored correctly.

When the bonded rubber cover is separated from the embedded metal projections and the metals in the rubber body become loose, it is time to consider replacement of the rubber track. 442 Excavator 30-80-4 Service Manual