Bobcat Company 442 — Cuts On The Lug Side Rubber

TRACK DAMAGE IDENTIFICATION (CONT’D) Causes Of The Damage: Cuts On The Lug Side Rubber Figure 30-80-13 making turns on projections, the lug side rubber surface will have an even higher chance to be cut. If the cuts run through the embedded steel cords, it might result in the steel cords' breakage due to their corrosion. It is highly recommended to repair the cuts with cold vulcanization rubber as soon as they are observed [Figure 30-80-13] . Cuts on the lug side rubber often occurs as one of the most typical failure modes [Figure 30-80-12] Replacement: When a cut on the lug side rubber reaches the embedded steel cords, it should be immediately repaired with cold vulcanization rubber.

Prevention: Machine operators are requested to drive with great attention to the ground's surface especially in terrains of the following type: Construction sites Demolition sites Paths covered with rocks and wood Concrete ridges Stumpy fields When operating on terrains as mentioned above, high speed, quick turns and overloading should be avoided. 442 Excavator 30-80-5 Service Manual Damage: Cuts Figure 30-80-12 PI-13045 When rubber tracks drive over projections or sharp stones in the fields, the concentrated forces applied P-4377 Cuts PI-13045 P-4377 PI-13045 When rubber tracks drive over projections or sharp stones in the fields, the concentrated forces applied P-4377