UPPERSTRUCTURE (CONT’D) Mark the track frame to swing bearing (Item 1) [Figure 40-10-3] . Removal And Installation (Cont’d) Drain the hydraulic reservoir. (See Replacing The Hydraulic Oil on Page 10-100-2.) Figure 40-10-4 Drain the fuel tank. (See Draining The Fuel Tank on Page 10-80-8.) Remove the swing motor. (See SWING MOTOR on Page 20-90-1.) Remove the swivel joint. (See SWIVEL JOINT on Page 20-80-1.) Remove the arm. (See ARM on Page 40-130-1.) 1 Remove the boom. (See BOOM on Page 40-120-1) 1 2 Remove the cab. (See CAB on Page 40-20-1.) P-40231 Remove the right side cover. (See RIGHT SIDE COVER on Page 40-160-1.) Remove the two bolts (Item 1) [Figure 40-10-4] . Remove the rear cover.
(See REAR COVER on Page 40- 150-1.) Remove the air cleaner mount (Item 2) [Figure 40-10-4] . Figure 40-10-5 Remove the seat. (See SEAT AND SEAT MOUNT on Page 40-30-1.) 2 Remove the engine. (See ENGINE (S/N 522311001 & ABOVE) on Page 60-60-1 or See ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) on Page 60-61-1.) Remove the counterweight. (See COUNTERWEIGHT on Page 40-170-1.) 1 Remove the air cleaner. (See AIR CLEANER on Page 60-30-1.) Figure 40-10-3 P-40236 Install the boom pivot pin (Item 1). Install a chain (Item 2) [Figure 40-10-5] on the pivot pin. 1 P-40242 442 Excavator 40-10-2 Service Manual