Bobcat Company 442 — Removal And Installation

UPPERSTRUCTURE (CONT’D) Figure 40-10-8 Removal And Installation (Cont’d) Figure 40-10-6 2 1 1 P-40234 Install a lifting bracket (Item 1) on the left front cab mount. Install a chain (Item 2) [Figure 40-10-6] on the lifting bracket. Figure 40-10-7 3 P-40253 Position the spreader bar (Item 1) [Figure 40-10-8] as shown and attach the lifting chains to the bar. 1 NOTE: The chain hoist the spreader bar and lifting chains are attached to must have a swivel hook to allow the upperstructure to be turned. 2 P-40233 Apply a small amount of lifting pressure to the upperstructure with the chain hoist. Install the rear lifting brackets (Item 1) using the counterweight bolt holes.

Use two 20 mm x 64 mm MC grade 8.8 bolts (Item 2) [Figure 40-10-7] to install the brackets. Install the chains (Item 3) [Figure 40-10-7] to the lifting brackets. 442 Excavator 40-10-3 Service Manual