Bobcat Company 442 — Removal And Installation

UPPERSTRUCTURE (CONT’D) Figure 40-10-15 Removal And Installation (Cont’d) Figure 40-10-13 1 2.0” (51 mm) 3.750” (95 mm) 1 P-40248 Install the bolts (Item 1) [Figure 40-10-15] until the bolt is 2.0 inches (51 mm) above the track frame. B-13678 Make four alignment pins by using 16 mm x 100 mm long MC bolts. Cut the head off of the bolts at 3.750 inches (95 mm), then taper the end [Figure 40-10-13] . Lower the upperstructure on to the track frame. Figure 40-10-16 Cut a slot (Item 1) [Figure 40-10-13] in the end of the bolts so the bolts can be removed with a flat blade screwdriver. Figure 40-10-14 1 1 1 1 1 P-40241 Install the bolts (Item 1) [Figure 40-10-16] .

Do not tighten the bolts at this time. Turn the upperstructure by hand and continue installing the bolts. Remove the alignment pins as the bolts are installed. After all thirty bolts have been installed, tighten the bolts to 206 ft.-lb. (279 N•m) torque. P-40247 Install the bolts (Item 1) [Figure 40-10-14] approximately 90Ч apart in the track frame. 442 Excavator 40-10-5 Service Manual