CAB (CONT’D) Cab Visor Removal And Installation Figure 40-20-72 1 1 1 P-40955 Remove the caps (Item 1) [Figure 40-20-72] from the bolts. Figure 40-20-73 2 1 1 1 P-40953 Remove the five bolts (Item 1) nuts and washers. Remove the urethane adhesive (Item 2) [Figure 40-20- 73] and remove the cab visor. Installation: Clean and dry the surface. Apply urethane adhesive (P/N 6808882). NOTE: The urethane adhesive has a four hour initial cure time and will achieve full strength after twenty four hours at 72 F (22 C) and fifty percent humidity. The cure time will be longer with lower temperatures and/or lower humidity. 442 Excavator 40-20-23 Service Manual