Bobcat Company 442 — Removal And Installation

BOOM (CONT’D) Figure 40-120-27 Removal And Installation (Cont’d) Figure 40-120-25 1 1 P-38265 Remove the boom pivot pin nut (Item 1) [Figure 40-120- 27] and washer. P-38269 Figure 40-120-26 Figure 40-120-28 1 1 P-38268 P-38266 Remove the boom pivot pin (Item 1) [Figure 40-120-28] . Install the boom cylinder base end retaining pin (Item 1) [Figure 40-120-25] & [Figure 40-120-26] and bolt. Move the boom away from the swing frame. Install the hoist as shown [Figure 40-120-25] & [Figure 40-120-26] . The boom will be balanced when the chain hoist is raised. Raise the boom until the arm end of the boom is approximately 37 inches (940 mm) above the ground. 442 Excavator 40-120-7 Service Manual