ARM (CONT’D) Figure 40-170-9 Removal And Installation (Cont’d) 1 Figure 40-170-7 P-38242 1 Remove the shims (Item 1) [Figure 40-170-9] from both sides of the cylinder rod end. P-38240 Place a block (item 1) [Figure 40-170-7] under the arm cylinder. Figure 40-170-10 Figure 40-170-8 1 1 P-38243 Remove the arm pivot pin nut (Item 1) [Figure 40-170- 10] and washer. P-38241 Installation: Tighten the nut until it is seated against the boom. Do not overtighten the nut and deflect the boom mounting plates. The arm must pivot freely. Remove the rod end retaining pin (Item 1) [Figure 40- 170-8] . 442 Excavator 40-130-3 Service Manual