TROUBLESHOOTING (CONT’D) Chart (Cont’d) 442 Excavator 60-10-2 Service Manual KEY TO CORRECT THE CAUSE 1. Battery capacity low. 26. Incorrect high pressure fuel lines. 2. Bad electrical connections. 27. Worn cylinder bores. 3. Faulty starter motor. 28. Worn valves and seat. 4. Incorrect grade of oil. 29. Broken, worn or sticking piston rings. 5. Low cranking speed. 30. Worn valve stems or guides. 6. Fuel tank empty. 31. Worn or damaged bearings. 7. Faulty stop control operation. 32. Not enough oil in the oil pan. 8. Plugged fuel line. 33. Switch/sensor is defective. 9. Plugged fuel filter. 34. Oil pump worn. 10. Restriction in the air cleaner. 35. Pressure relief valve is sticking open. 11.
Air in the fuel system. 36. Pressure relief valve is sticking closed. 12. Faulty fuel injection pump. 37. Broken relief valve spring. 13. Faulty fuel injectors. 38. Faulty suction pipe. 14. Broken injection pump drive. 39. Plugged oil filter. 15. Incorrect injection pump timing. 40. Piston seizure. 16. Incorrect valve timing. 41. Incorrect piston height. 17. Poor compression. 42. Faulty engine mounting. 18. Plugged fuel tank vent. 43. Incorrect alignment of flywheel. 19. Incorrect grade of fuel. 44. Faulty thermostat. 20. Exhaust pipe restriction. 45. Plugged oil cooler 21. Cylinder head gasket leaking. 46. Plugged PCV system 22. Overheating. 47. Damaged valve stem oil deflectors. 23.
Cold running. 48. Plugged oil pump pipe strainer. 24. Incorrect tappet adjustment. 49. Broken valve spring. 25. Sticking valves.