ENGINE COMPONENTS AND TESTING (S/N 522311001 & ABOVE) Figure 60-50-2 Engine Compression Checking Check and adjust the valve clearance as needed. (See Valve Clearance Adjustment on Page 60-50-23) The tools listed will be needed to do the following procedure: MEL 10630 - Engine Compression Tester MEL 1489 - Compression Test Adapter IMPORTANT P-63087 Do not bend the high pressure fuel injection tubes when removing or installing them. Remove the valve cover [Figure 60-50-2] . Installation: Tighten the bolts to 6-7 ft.-lb. (8-10 N•m) torque. I-2029-0289 Figure 60-50-1 Figure 60-50-3 1 P-63086 P-63089 Disconnect the wire harness (Item 1) [Figure 60-50-1] from the fuel shut off solenoid.
Remove the fuel injector lines from the fuel pump and fuel injector [Figure 60-50-3] . Installation: Preload the injector cap nuts to 4 ft.-lb. (5 N•m) torque. Final tighten the nuts to 18-21 ft.-lb. (25- 28,5 N•m) torque. NOTE: Do not rebend or reuse fuel injector lines. 442 Excavator 60-50-1 Service Manual