ENGINE COMPONENTS AND TESTING (S/N 522311001 & ABOVE) (CONT’D) Figure 60-50-50 Fuel Injection Pump Installation (Cont'd) Figure 60-50-48 P-61955 Loosen the injector clamp bolts [Figure 60-50-50] . P-61957 Installation: Tighten the injector clamp bolts to 12-15 ft.- lb. (16-21 N•m) torque. Remove the fuel return lines [Figure 60-50-48] . Figure 60-50-51 NOTE: Do not reuse the fuel return lines. Figure 60-50-49 P-61954 P-61956 Remove the injector high pressure fuel lines [Figure 60- 50-51] . Installation: Install a new seal on the fuel lines and hand tighten. Remove the fuel line cap nuts [Figure 60-50-49] . Installation: Preload the cap nuts to 4 ft.-lb. (5 N•m) torque.
Tighten the cap nuts to 18-21 ft.-lb. (25-28,5 N•m) torque. NOTE: Do not rebend or reuse the fuel injector lines. 442 Excavator 60-50-17 Service Manual