Bobcat Company 442 — Fuel Injector, Checking

ENGINE COMPONENTS AND TESTING (S/N 522311001 & ABOVE) (CONT’D) Fuel Injector, Checking Fuel Injection Pump Installation (Cont'd) IMPORTANT Figure 60-50-52 Do not disassemble or test the fuel injector nozzles unless you have the correct service and testing tools. WARNING Diesel fuel or hydraulic fluid under pressure can penetrate skin or eyes, causing serious injury or death. Fluid leaks under pressure may not be visible. Use a piece of cardboard or wood to find leaks. Do not use your bare hand. Wear safety goggles. If fluid enters skin or eyes, get immediate medical attention from a physician familiar with this injury. P-61953 Remove the fuel injector clamps and bolts [Figure 60-50- 52] .

W-2072-0496 Figure 60-50-53 The tools listed will be needed to do the following procedure: OEM1064 - Injection Nozzle Test OEM1065 - Accessory Set Figure 60-50-54 P-61952 Remove the injectors [Figure 60-50-53] . Installation: Lightly grease the seal on the injectors. B-8971 NOTE: The return line fitting must face the exhaust side. Connect the nozzle to the test pump, in a down position [Figure 60-50-54] . Operate the test pump until the nozzle valve opens: Injection Pressure:3625-3741 PSI. (250-258 bar) 442 Excavator 60-50-18 Service Manual