Bobcat Company 442 — Fuel Injector Disassembly

ENGINE COMPONENTS AND TESTING (S/N 522311001 & ABOVE) (CONT’D) Figure 60-50-57 Fuel Injector Disassembly Figure 60-50-55 1 2 4 5 6 3 CD-15333 Disassemble the parts as shown in [Figure 60-50-57] . 1. Nozzle Cap Nut 2. Injector Nozzle 3. Adapter 4. Thrust Pin 5. Spring 6. Shim(s) Wash all the parts in clean diesel fuel and blow dry using compressed air. Check nozzles spray pattern [Figure 60-50-55] : The spray pattern must be uniform from all four holes of the nozzle. The nozzles are dirty or defective: If the spray pattern is not uniform. If fuel drips from the end of the nozzle. If the spray is a solid stream instead of a mist.

Figure 60-50-58 Figure 60-50-56 CD-15334 The nozzle needle and body [Figure 60-50-58] are lapped together and can not be exchanged with other nozzle parts. CD-15332 DO NOT touch the nozzle needle with your fingers. Remove the nozzle cap nut [Figure 60-50-56] . When the nozzle body is held in the upright position, the needle should by its own weight slide slowly and smoothly on its seat [Figure 60-50-58] . 442 Excavator 60-50-19 Service Manual M M C-2177