ENGINE COMPONENTS AND TESTING (S/N 522311001 & ABOVE) (CONT’D) Figure 60-50-69 CRANKSHAFT POSITION ONE Turn crankshaft until valves of cylinder No. 1 Over lap CRANKSHAFT POSITION TWO Turn crankshaft further by one complete revolution (360°) Valve Clearance Adjustment Make the valve clearance adjustment with the engine stopped and cold. Remove the valve cover and crankcase breather. DO NOT ADJUST ADJUST Figure 60-50-67 MC-2174 Use the following sequence as shown in [Figure 60-50- 69] to set the valve clearance. Turn the crankshaft until the valves of cylinder No. 1 over-lap [Figure 60-50-69] . P-61964 Turn the crankshaft by one complete revolution (360°) and set the other valves.
Figure 60-50-70 When installing the valve cover bolts, tighten the bolts to 6-7 ft.-lb. (8-10 N•m) torque [Figure 60-50-67] . Figure 60-50-68 P-63103 Loosen the locknut and turn the set screw until the clearance is correct [Figure 60-50-70] . P-63104 When installing the crankcase breather bolts, tighten the bolts to 6-7 ft.-lb. (8-10 N•m) torque [Figure 60-50-68] . Intake - 0.012 inch (0.3 mm) Exhaust - 0.020 inch (0.5 mm) Tighten the locknut to 13-16 ft.-lb. (18-22 N•m) torque. 442 Excavator 60-50-23 Service Manual