ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) IMPORTANT Engine Compression Checking Check and adjust the valve clearance as needed. (See Valve Clearance Adjustment on Page 60-51-28.) Do not bend the high pressure fuel injection tubes when removing or installing them. I-2029-0289 The tools listed will be needed to do the following procedure: MEL 10630 - Engine Compression Tester MEL 1433 - Compression Test Adapter Installation: Tighten the fuel line nuts to 10-12 ft.-lb. (13.5 - 16.5 N•m) torque. Warm the engine. Figure 60-51-3 Clean the area around the fuel injection pump and injectors.
Figure 60-51-1 1 1 P-58312 Remove the bolt (Item 1) [Figure 60-51-3] and injector retainer. P-58310 Installation: Tighten the bolt to 16 ft.-lb. (21 N•m) torque. Disconnect the wire harness (Item 1) [Figure 60-51-1] from the fuel shutoff solenoid. Figure 60-51-2 1 P-58311 Remove the high pressure fuel line (Item 1) [Figure 60- 51-2] from the fuel pump and fuel injector. 442 Excavator 60-51-1 Service Manual