CAB TILT PROCEDURE (CONT’D) Figure 10-160-22 Tilting The Cab (Cont’d) Figure 10-160-20 1 1 P-33040 Install a winch (Item 1) [Figure 10-160-22] to the clevis on the cab. Install the other end of the winch to the chain that was installed on the arm. P-33039 Install the clevis (Item 1) [Figure 10-160-20] on the right (as viewed from the operator’s seat) corner of the cab. IMPORTANT Figure 10-160-21 When tilting the cab, use winches and chains that are in good condition and of proper weight ratings. 2 I-2215-0502 Lower the left console and close the cab door. 1 Figure 10-160-23 P-33041 1 Install a chain (Item 1) around the arm between the bucket and the bucket link (Item 2) [Figure 10-160-21] .
2 P-33036 Winch the cab forward until the front of the cab (Item 1) contacts the bumpers (Item 2) [Figure 10-160-23] . 442 Excavator 10-160-6 Service Manual