Bobcat Company 442 — Tilting The Cab

CAB TILT PROCEDURE (CONT’D) Figure 10-160-25 Tilting The Cab (Cont’d) Figure 10-160-24 1 2 1 P-33046 Reverse the direction of the winch and lower the cab until the approved cab support device (Item 1) [Figure 10- 160-25] fully engages the cab mount hole and the weight of the cab is resting on the support device. Figure 10-160-26 3 1 P-33045 Install an approved cab support device (Item 1) through the cab mount hole (Item 2) and over the rear cab mount stud (Item 3) [Figure 10-160-24] . P-33047 Install the nut (Item 1) [Figure 10-160-26] on the cab mount stud. WARNING Avoid injury or death. Never work under the excavator cab without installing an approved cab support device.

W-2435-0502 442 Excavator 10-160-7 Service Manual