ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-9 Checking the Manifold Heater Open the right side cover. Figure 60-51-8 1 2 P-58328 Connect one lead from the multimeter to the terminal (Item 1) [Figure 60-51-9] . 1 Connect the other lead to the base of the heater (Item 2) [Figure 60-51-9] . P-58327 Remove the nut, washer and wire harness (Item 1) [Figure 60-51-8] from the manifold heater. The reading must be approximately 0.5 ohms. If the resistance is zero ohms, the heater has a short circuit and must be replaced. Use a multimeter to measure the resistance of the heater.
If the resistance is infinite, the coil of the heater is broken and the heater must be replaced. 442 Excavator 60-51-3 Service Manual