Bobcat Company 442 — Fuel Injection Pump Installation

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-29 Fuel Injection Pump Installation Figure 60-51-27 1 1 P-56995 Use the centering pin MEL-1467 to remove the press-in plug (Item 1) [Figure 60-51-29] from the injection pump. P-56988 Figure 60-51-30 Remove the plug from the engine block. Install control rack locating pin MEL-1459 (Item 1) [Figure 60-51-27] . 1 Figure 60-51-28 3 2 B-23275 Install the centering pin (Item 1) into the injection pump and into the control lever (Item 2). Align the marks (Item 3) [Figure 60-51-30] on the pump body and the control lever. Make sure the control lever is in the center position.

P-56989 Rotate the camshaft until the tappet stroke is at B.D.C. [Figure 60-51-28] . Tighten the locating pin. 442 Excavator 60-51-10 Service Manual