ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-58 Timing Belt Removal NOTE: The timing belt can be replaced in the excavator. The procedure is shown with the engine removed for photo clarity. To remove the belt with the engine installed, remove the radiator/oil cooler. (See RADIATOR/OIL COOLER (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) on Page 60-41-1.) Remove the bolts (Item 1) [Figure 60-51-55 on Page 19] from the timing belt inspection cover. P-58798 1 Remove the torx bolt (Item 2) [Figure 60-51-55 on Page 19] . Remove the shield (Item 1) [Figure 60-51-58] . Remove the cover (Item 3) [Figure 60-51-55 on Page 19] .
Figure 60-51-59 Figure 60-51-57 1 2 1 2 P-58800 P-58797 Disconnect the wire harness (Item 1) [Figure 60-51-59] from the alternator. Remove the bolts (Item 1) from the V-belt pulley (Item 2) [Figure 60-51-57] . Remove the nuts and wire harness (Item 2) [Figure 60- 51-59] . Remove the V-belt pulley. 442 Excavator 60-51-20 Service Manual