Bobcat Company 442 — Timing Belt Inspection

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-56 Timing Belt Inspection NOTE: The timing belt is maintenance free. Timing belts that are in operation do not need to be re-tensioned. The timing belt, belt tensioner and mount bolt must be replaced every 3000 operating hours or every 5 years. A repair kit is available. NOTE: If the timing belt has to be removed before 200 hours of engine operation, the timing belt can be re-used and re-tensioned according to the procedure listed. P-58326 To do the following procedure you need the following tool: Check the timing belt, sprockets and tensioner for wear, cracks or damage [Figure 60-51-56] .

ME-1552 - Torx Bit Figure 60-51-55 Check the timing belt in detail for the following conditions, replace as needed. 1. Oil deposits 2. Hardened back rubber surfaces 3. Cracked 4. Badly worn teeth 5. Missing tooth 6. Side of belt badly worn 7. Side of belt cracked 1 3 P-58315 2 Remove the bolts (Item 1) [Figure 60-51-55] from the timing belt inspection cover. Remove the torx bolt (Item 2) [Figure 60-51-55] . Remove the cover (Item 3) [Figure 60-51-55] . 442 Excavator 60-51-19 Service Manual