ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-86 Valve Clearance Adjustment Make the valve clearance adjustment with engine stopped and cold. Remove the valve cover. Figure 60-51-84 P-56712 Loosen the locknut and turn the set screw until the clearance is correct [Figure 60-51-86] . Intake - 0.012 inch (0.3 mm) Exhaust - 0.020 inch (0.5 mm) Tighten the locknut to 13-16 ft.-lb. (18-22 N•m) torque. P-56714 When installing the valve cover bolts, tighten to 75 in.-lb. (8.5 N•m) torque [Figure 60-51-84] . Figure 60-51-85 Use the following sequence as shown in [Figure 60-51- 85] to set the valve clearance.
Turn the crankshaft until the valves of cylinder No. 1 over- lap [Figure 60-51-84] . Turn the crankshaft by one complete revolution (360°) and set the other valves. 442 Excavator 60-51-28 Service Manual CRANKSHAFT POSITION ONE Turn crankshaft CRANKSHAFT POSITION TWO Turn crankshaft further by until valves one complete revolution of cylinder No. 1 Overlap (360)° DO NOT ADJUST ADJUST F F L L Y Y W W H H E E E E L L MC-2174 MC-2174