ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-51-94 Thermostat, Oil Pressure Control Valves & Heater Connections Figure 60-51-92 1 Remove the plug and O-ring (Item 1) [Figure 60-51-92] . Remove the thermostat and spring assembly (Item 1) [Figure 60-51-94] from the engine block. P-58322 Installation: Install the plug and tighten to 82 ft.-lb. (111 N•m) torque. Figure 60-51-93 Remove the plug and O-ring (Item 2) [Figure 60-51-93] and remove the spring and oil pressure control valve (Item 2) [Figure 60-51-94] from the engine block. Installation: Install the plug and tighten to 82 ft.-lb. (111 N•m) torque.
2 4 3 Remove the heater hose, fitting (Item 3) [Figure 60-51- 93] , and O-ring (Item 3) [Figure 60-51-94] . Installation: Install the fitting and tighten to 82 ft.-lb. (111 N•m) torque. 5 P-58324 Remove the plug and O-ring (Item 4) [Figure 60-51-93] Remove the spring and oil pressure control valve (Item 4) [Figure 60-51-94] from the engine block. Installation: Install the plug and tighten to 82 ft.-lb. (111 N•m) torque. Remove the heater hose, fitting (Item 5) [Figure 60-51- 93] , and O-ring (Item 5) [Figure 60-51-94] . Remove the valve and spring (Item 6) [Figure 60-51-94] from the engine block. Installation: Install the fitting and/or plug and tighten to 82 ft.-lb. (111 N•m) torque. NOTE:
Be sure the valve and spring (Item 6) [Figure 60-51-94] is installed as shown. 442 Excavator 60-51-31 Service Manual 1 2 3 4 5 6 B-14310 B-14310