Bobcat Company 442 — Thermostat, Oil Pressure Control Valves & Heater Connections

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Installation : See “Thermostat, Oil Pressure Control Valves & Heater Connections” on page 31. [Figure 60- 51-94] for location on the engine block. Thermostat, Oil Pressure Control Valves & Heater Connections (Cont'd) Figure 60-51-97 Figure 60-51-95 1 2 2 1 3 N-18871 N-18868 Replace the O-ring (Item 1). Remove the spring (Item 2) from the oil pressure control valve (Item 3) [Figure 60- 51-97] . Remove the thermostat spring (Item 1) from the thermostat (Item 2) [Figure 60-51-95] , inspect all parts and replace as needed. The spring is marked with a red mark, for proper installation.

If the red mark is missing, the spring coil diameter is 0.055 inch (1,4 mm). Installation: See “Thermostat, Oil Pressure Control Valves & Heater Connections” on page 31. [Figure 60- 51-94 on Page 31] for location on the engine block. Installation: See “Thermostat, Oil Pressure Control Valves & Heater Connections” on page 31. [Figure 60- 51-94 on Page 31] for location on the engine block. Figure 60-51-96 3 2 1 N-18869 Remove the spring (Item 1) from the oil pressure control valve (Item 2). Replace the O-ring (Item 3) [Figure 60- 51-96] . The spring is marked with a yellow mark, for proper installation. If the yellow mark is missing, the spring coil diameter is 0.047 inch (1,2 mm).

442 Excavator 60-51-32 Service Manual