Bobcat Company 442 — Aneroid Device

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Aneroid Device WARNING Rotating fan blade can cause serious injury or death. Keep away from fan and moving parts. Do not operate with guard removed. Description The aneroid device is used to control exhaust smoke during acceleration or when a sudden load is placed on a turbo-charged engine. This is accomplished by delaying the fuel control rack from moving into the higher fuel setting until the turbo-charger has time to provided sufficient intake manifold pressure to assure the correct “air fuel mixture” to the combustion chambers.

If the intake manifold pressure is low, the fuel delivery will be reduced to prevent exhaust smoke. Once the intake manifold pressure has reached a predetermined pressure, the aneroid device will allow the injection pump control rack to move to a higher fuel setting and enable the engine to produce more power, while controlling exhaust smoke output. Hot surfaces can cause injury. Do not touch. Allow to cool before servicing. W-2521-0106 The following components will be needed for testing the aneroid device for proper function:

Fuel Pressure Gauge - 0 - 30 PSI (0 - 60” HG) Boost Pressure Gauge (must also fabricate an adapter to go from the gauge threads to fit into the manifold threads) The only time the aneroid device should be tested or adjusted is if excessive loss of engine RPM is evident when a hydraulic pump load is applied to the engine. This condition can occur when two hydraulic functions are required at the same time (one of these functions must work the gear pump). Example: engaging the swing circuit and the blade circuit at the same time. Infrared Heat Sensor [must read a minimum 1000° F.

(538 ° C.)] Photo tach Testing Figure 60-51-99 Use the following information to determine if the aneroid needs adjustment: NOTE: Two people will be required for doing this procedure. One person must stay in the excavator cab to operate the machine, the second person to monitor gauges at the engine. Before checking the aneroid function, make sure that the engine is operating correctly. Make sure the fuel filters are clean and fuel lines are not restricting fuel flow. Are the air filters clean and no damage to the intake system. Check to make sure the engine speed control lever is adjusted to reach it’s maximum stop so full engine RPM is available.

Check exhaust system for leaks, damage or restrictions. 1 P-58327 Remove the nut, washer and wire harness (Item 1) [Figure 60-51-8] from the manifold heater and remove the manifold heater. (Tape the end of the manifold heater wire so that it does not ground out during the test.) WARNING Turbochargers, operate at high speed and high temperatures. Keep fingers, tools and other objects away from the inlet and outlet ports. Avoid contact with hot surfaces. Install an adapter and the Boost Pressure Gauge into the manifold heater opening. W-2257-1196 442 Excavator 60-51-34 Service Manual