Bobcat Company 442 — Aneroid Device

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) 1. Bring the engine to high idle (approximately 2400 RPM) and verify the engine speed with the photo tach. Aneroid Device (Cont’d) 2. Check fuel pressure, the fuel pressure should be between 8 - 12 PSI (0,55 - 0,82 bar). This will be difficult to read as the pressure gauge will be pulsing due to the transfer pump. Testing (Cont’d) Figure 60-51-100 3. Read the intake manifold pressure. The reading should be between 9 - 12 PSI (0,62 - 0,82 bar) or 20 - 24” HG. If these readings can be obtained, the engine is operating properly, continue to step 4.

If these readings can not be obtained, further engine evaluation is needed to determine fuel restrictions, air restrictions, etc.. 1 4. Take an exhaust temperature reading at 2 - 3 in. from the exhaust outlet of the turbo-charger. The temperature should be between 850 - 900° F. (455 - 482° C.) 5. Have the operator in the cab raise the boom and the blade fully until both the relief valves goes over relief. P-56410A Disconnect the fuel line (Item 1) [Figure 60-51-98] at the filter and install the fuel pressure gauge at this location. 6. The second person should note the manifold pressure, the fuel pressure and monitor the engine RPM.

This test must be done with the engine and the hydraulic fluid at operating temperature, 150° F. (66° C.). 7. If the manifold pressure starts to drop off and the engine RPM starts to fall, and black exhaust smoke is present, this is an indication that an adjustment to the aneroid is needed. (IF the engine pulls down for a short period of time and then start to recover without producing black smoke, the aneroid is set correctly.) WARNING Turbochargers, operate at high speed and high temperatures. Keep fingers, tools and other objects away from the inlet and outlet ports. Avoid contact with hot surfaces. 8. Decrease engine RPM, lower boom fully and lower blade to the ground.

Stop the engine and remove the key. 9. If aneroid adjustment is needed, proceed to the adjustment procedure. If no adjustment is needed, remove the gauges and reinstall all the existing components. W-2257-1196 WARNING Rotating fan blade can cause serious injury or death. Keep away from fan and moving parts. Do not operate with guard removed. Hot surfaces can cause injury. Do not touch. Allow to cool before servicing. W-2521-0106 With the second person in the excavator cab, start the engine and bring the excavator to operating temperature. 442 Excavator 60-51-35 Service Manual