Bobcat Company 442 — Aneroid Device

ENGINE COMPONENTS AND TESTING (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Once the correct adjustment has been reached, the engine will pull down for a short period of time and will start to recover without producing black smoke. Aneroid Device (Cont’d) Adjustment When adjustment is complete: remove all test equipment and reinstall all the original components that were previously removed. The aneroid is located in the fuel filter housing. There are two lock nuts and adjustment screws on the filter housing. Make sure you are adjusting the correct screw as shown below. Start the engine and run at high idle for a few minutes. Return engine to low idle and stop the engine.

Check for leaks and repair or replace as necessary. Figure 60-51-101 1 2 1 1 P-56410B NOTE: Before making any adjustment, mark the adjustment screw so that it can be returned to the original setting if required. Loosen the lock nut (Item 1) [Figure 60-51-101] and turn the adjustment screw DO NOT adjust (Item 2) [Figure 60-51-101] . Turn the adjustment screw IN 1/2 turn and tighten the lock nut (Item 1) [Figure 60-51-101] . Repeat the test procedure. Decrease engine RPM, lower boom fully and lower blade to the ground. Stop the engine and remove the key If further adjustment is needed, Loosen the lock nut (Item 1) [Figure 60-51-101] and turn the adjustment screw an additional 1/2 turn IN.

Tighten the lock nut. Repeat this procedure until the correct adjustment is reached. DO NOT turn the adjustmrnt screw IN more than five full turns. If adjustment is not possible before the five full turns, return the adjustment screw to the original setting and contact your Bobcat dealer. 442 Excavator 60-51-36 Service Manual